@fcwilt Thanks all installed

@jay_s_uk Yes that is during print. No data received.

@fcwilt Thanks all installed

@diy-o-sphere Thanks all installed succesfully. Now I am trying to get the magnetic filament sensor to work. After updating to 2.05.1 I just get:
Duet3D magnetic filament monitor on input 3, enabled, sensitivity 24.80mm/rev, allow 70% to 130%, check every 10.0mm, no data received.
Cables are fine all is rotating when filament is pulled but no data? Only one green flash after switch on. Any suggestions?

I am trying to get the magnetic filament sensor to work. After updating to 2.05.1 I just get:
Duet3D magnetic filament monitor on input 3, enabled, sensitivity 24.80mm/rev, allow 70% to 130%, check every 10.0mm, no data received.
Cables are fine all is rotating when filament is pulled but no data? Only one green flash after switch on. Any suggestions?

Server is running but only white window when I connect to IP. Duet webControl 2.07 zip only has .gz files and folders. How do I install these on Duet2 ?

@fcwilt Thanks, I installed 2.05 and Duet wifi server but there is nothing on how to install Duet webControl. Zip contains folders and .gz files. server is starting but nothing shows up when connecting to the IP ( blank white window).

I need to install Version 2.05.1
DuetWiFiServer 1.23
DuetWebControl 2.0.7 or 1.22.6

Where do I find the files? I see Changelogs etc but no files to install.

No I cannot update to 3 already f'ed up all trying that.

Updated with DuetWiFiServer. Panel shows the web server started and IP but blank screen in DWC when I connect to the IP. Please advise.

@diy-o-sphere Now DWC is offline. panel shows the web server started but blank screen when I connect to the IP. I am not trying to upgrade from 2 to 3 just 2.02 to the latest 2 to use the magnet sensor.

@diy-o-sphere What? Please elaborate. Is there a better description?