Posts made by Edkirk

Re: Duet3D announces new tool board at FormNext Is it possible to use two different Roto TBs on one system? I thought I read somewhere that there wasn't support for 2 or more of the Roto TB on the same system. If so where do I fine supporting documentation? Thanks, Ed

@dc42 Great, Thank you. I am using the new tool board on a full size extruder/hot end. Awesome combination. I am thinking about getting another one for my delta/smart effector, sure cleans up the wiring and much more convenient and easier to work with. Thanks, Ed

I have the board up and running, I am getting low on the little white connector pins. They are very fragile and I almost out. Where can I get some more of the metal connectors? Are they the same as used on the Smart Effector? Thanks, Ed

I am a go, I support all of your specifications. Although I am sold on the E3D rapid change nozzles.
Thanks, Ed

Are there plans for a Delta Smart Effector with built-in Tool Board, I would install on my Delta?

New Duet3D tool board up and running on Voron Trident, with Tap on Z axis for homing and bed leveling. Micro Swiss NG extruder, E3d heater and nozzle.

@dc42 Where do I find package feed?

I have ordered the new tool board to install on my Voron Trident with Micro Swiss NG Extruder, E3D hotend using Duet IR Probe for Z probe. I see in the Duet 3 Roto Toolboard documentation under Firmware notes "Compatible RepRapFirmware version 3.5 or later". I updated my 6HC with SBC which only goes up to 3.4.6, is there going to be any problems using 3.4.6 or do I have to wait for 3.5?

I plan on using a Voron Tap Z-Probe with optical sensor (not Duet IR probe I am currently using) then when I have everything working converting the Tap optical to Piezo from Precision Piezo to work like the Delta Smart Effector so the Tap probe will be a true tap probe like the Delta Smart Effector. Does this configuration look like it will work? Thanks, Ed

@chine Several years ago I built a Corexy to test Clearpath Servos, I had no problems. Absolutely awesome performance. Looking through the above post I didn’t see any mention of power voltage and current to power the servos. I used a power supply from Clearpath for Servo power. I was initially concerned about signal voltage from the duet board for step/direction but there was no problem. I set Clearpath resolution to get close to my original steps per mm in config.g. I found the servos were over kill for a 3D printer, they are no better then the signal from the board just producing slightly better then a good stepper motor. They are very quiet. I transplanted the servos to my CNC router where I needed the extra power. Photo of the original test printer.
Ed Kirk

@Phaedrux Thanks for the help, I managed to figure it out on my own.

I am satisfied with my setup, not the problem. Already contacted E3D for a quote on their printer and looking forward to my next project.

Thanks, Ed

@bearer Yes it is rendered differently and I did not recognize it.

Simple question with a simple answer, that’s why I ask the experts.

Thanks, Ed

Select files. Done

Click cloud.

Click on blue circle bottom right corner.

Duet/Pi control system with E3D Tool Changer config files installed, great setup.

Thank you Duet for a great product.

Ed