Can we get the current Z height displayed on the print info screen (next to the current z probe value -- I think the print info screen shows the current Z probe value..)?

Hi,
I updated from old Paneldue v1.1 to a v3. The big screen.
Everything was working fine after the upgrade... Including touch.
Yesterday I turn the printer on and although the display works, the touch does not. What is wrong?
Power cycle, power cycle, power cycle, no luck.

@jay_s_uk ahhh thank you.

I am upgrading from RR2 to RR3. Reading through the RR3 overview. Have not made it all the way through yet but my head bed triggers a heater fault because it heats up at ~0.41C /sec when it is expecting 1.71C /sec... It IS working...

Nothing obvious. Continuing to read....

What am I missing?

Some config goodness -

; Heaters
M308 S0 P"bedtemp" Y"thermistor" T100000 B4138              ; configure sensor 0 as thermistor on pin bedtemp
M950 H0 C"bedheat" T0                                       ; create bed heater output on bedheat and map it to sensor 0
M307 H0 B0 S1.00                                            ; disable bang-bang mode for the bed heater and set PWM limit
M140 H0                                                     ; map heated bed to heater 0
M143 H0 S120                                                ; set temperature limit for heater 0 to 120C

@eddiie I found it on the datasheet. "Recommended External Series Resistor" 27 ohms. Same as R2.

Of course I ripped off the usb connector some years ago. Trying to reconnect something now to upgrade the firmware but it isnt working.

R3 seems to be broken in my attempts to attach a wire to it.

Can someone tell me what the value of R3 is on the Paneldue 1.1 board? Is it the same as R2? which reads ~24 ohms?

Thank you. Looks like I can get a newer controller from Filastruder. Should I get it?

I am still a bit confused here. Is the screen used on the paneldue 1.1 still usable with newer paneldue controller?

I want to move to RRF 3

A few years ago out of frustration I put this mini kossel printer away. Recently I started rebuilding parts of it... Today I went to look at upgrading firmware on the different components... To my surprise there are Paneldue "i" types now, version 2, version 3 of panel due.

My DuetWifi controller board that has about 36 hours used is probably outdated too.

Was there an upgrade board released at some time to go from the Paneldue v1.1 to whatever the latest version is now?

What is different between the 7 and 7i ?

@deckingman good to hear from you.
Thanks for breaking that down a bit better.

Lately I've been fighting with clolor fade/bleeding. Could this be a firmware bug too?
A color (any of them) no matter how big the prime tower is, the back of the models print magenta in the back, and it slowly fades to the correct color by the time it gets to the front of the model. does this make sense? I will make a post later.

That is great news! Thanks guys.