Topics created by Dumbo

Thanks for the help I have changed a few things on you setup but getting there. Thank you very much

If it's an E3Dv6 hot end, check that you have assembled it correctly. There should be a gap of about 2mm between the top of the hearer block and the bottom fin of the heatsink.

I used to have that scraping issue sometimes as my bed was not well trammed and without the mesh it would be too close in places if you didn't give it some +z on move. To start I did the typical paper tramming, but then used the mesh visualization to start tramming the bed better. After a few rounds of that I had much less slope in the mesh bed compensation. Then I went through the process of setting the z offset for the probe in the wiki again and I can usually print without any babystepping anymore. I also replaced my adjuster knobs with those nylon cored locknuts so they wouldn't vibrate loose and lose my settings.

I agree. @Veti, I suggest you submit a warranty claim.

sorted it with your help thanks