Unfortunately, i was not so careful and I did not had the WWW folder on the SD card. That's why it did not work.
Best posts made by DR8
-
RE: Problem by connecting to duetwifi from browser
-
Configuring Slicer
Hi,
I don't know if here it's the best place to post this kind of topic but…. I'm wondering what slicer duet users use in order to achieve great prints. I was using Cura 2.6 And I had really nice looking prints. But because Cura 2.6 can't work with relative extrusion I installed the 3.0 one. The main advantage here is that I can use relative extrusion and also I can benefit from power outage protection feature. The problem is that with the same settings imported from Cura 2.6 into 3.0 I can't achieve the same quality of prints. They don't look bad but it's under my standard. Then I tried slic3r because it can support relative extrusion. Alot of tweaking but still, not awesome results. My main problems are small blobs and zits at the seam position. I did not had them in Cura 2.6. I have increased coasting and retraction extra prime( negative ) values, I tweaked the extrusion width and so on. Still not the results that I was expected.
So, what are you guys using as a slicer that support relative extrusion mode and maybe you are willing to post some values (pictures) also. Oh, BTW I'm using a bowden tube system 70cm long.
-
RE: Error: M24: Cannot resume while power voltage is low
Oh s..t,
Now I see the problem.I have another duet on other printer witch is on 24V. Jeez, I'm gonna loose my head one day. Thaks a lot.