I’m experimenting with 4 motors on Z and worried about keeping them in sync. Was thinking 2 in series on each of the 2 ports. Thoughts?
Posts made by cts5191
-
RE: Duet 3 - Multiple motors on one driver
-
Duet 3 - Multiple motors on one driver
Since the Duet 3 has higher amp drivers, is it now possible to have more motors on one driver? I’m trying to avoid buying an expansion board.
-
RE: Change the Router Duet WiFi don't work (ok but....)
I had to remove the space in my SSID name for it to work and make it all caps, since I was using proterface.
-
Motors “bang” at power up during home (x/y)
When I home x and y, they power up and slam into motion. my Motors for x and y are set around 70% current. Kysan 1.8 degree 1.5amp nema 17.
Any clue to why they would jerk so hard while powering up when start to home?
Seems to work fine during printing. No binding on the rails. Jerk and accelerations are pretty tame.