I’m experimenting with 4 motors on Z and worried about keeping them in sync. Was thinking 2 in series on each of the 2 ports. Thoughts?
Latest posts made by cts5191
-
RE: Duet 3 - Multiple motors on one driver
-
Duet 3 - Multiple motors on one driver
Since the Duet 3 has higher amp drivers, is it now possible to have more motors on one driver? I’m trying to avoid buying an expansion board.
-
RE: Change the Router Duet WiFi don't work (ok but....)
I had to remove the space in my SSID name for it to work and make it all caps, since I was using proterface.
-
Motors “bang” at power up during home (x/y)
When I home x and y, they power up and slam into motion. my Motors for x and y are set around 70% current. Kysan 1.8 degree 1.5amp nema 17.
Any clue to why they would j**k so hard while powering up when start to home?
Seems to work fine during printing. No binding on the rails. J**k and accelerations are pretty tame.