Topics created by Craigrobbo

@Craigrobbo Removing the ! worked thank you

@oliof said in BIQU microprobe issues:

@Craigrobbo are you saying BLTouch works after separating out the wiring, or Microprobe, or both?

The BLtouch worked when the cables re within the wiring loom and the same when seperated too.

@Craigrobbo As it says in https://docs.duet3d.com/User_manual/Machine_configuration/Configuration_laser#connecting-laser

You can use one of the 5V PWM pins on the DueX.

It should probably say

This assumes that your laser is capable of being controlled by a 5V PWM signal; can it? What laser/controller is it?
See the wiring diagram here for the PWM connections: https://docs.duet3d.com/Duet3D_hardware/Duet_2_family/DueX2_and_DueX5#wiring-diagram

Ian

@stephen6309 said in Huge overshoot on heating and rapid cooling after PID:

e cooling fan to not blow on the

Im using the exact command you given me, M303 follows by the T0 and i am using S200 as its my most common temp

Please post your full config.g and homing files. Also share the results of M122 and M98 P"config.g"

In general, double check your motor wiring, and make sure that -x moves to the left, +x moves to the right, -y moves to the front, +y moves to the back. Change the motor direction of rotation as needed and ensure the direction of the homing moves is positive or negative as needed. The endstop positions must also be accurately defined in M574.