@Classified

Solved. My fan died…

@gtrider

Trank YouTube this helped and the extruder works Fine

Hey Guys

I am almost desperately trying to connect my Delta fan FFB0412EN-00.
I have connected the fan in the same way as the data sheet or the previous configuration on an Octopus Pro board. But I seem to be getting a short circuit on the Duet, the board won't start or simply shuts down.
Black and red are for + and -, connected to GND and V_OUTLC1.

The part in the Config.g looks like this:
; Fans
M950 F0 C "out4+out4.tach" Q25000
M106 P0 S0 H-1 C "Layer Fan"

Is the fan perhaps not compatible? Or does it seem to be defective due to the conversion?

Any suggestions?

Hello everyone,

I am in the process of converting my 3D printer (RatRig Vcore 3.1) to Duet.
However, I am currently failing because of the extruder, an Orbiter 1.5.

Can anyone tell me how to wire it up? In other words, which colour from the motor has to go to which position in the connector?

Thanks in advance