Topics created by Chipsa82

We use the 6-pin Microfit 3.0 connector on the Smart Effector to connect the heater and fan wires. They are good, however once you have inserted the pins into the shell, they are impossible to remove without a special (and expensive) tool.

Due to the risk of miswiring, we put the low voltage connections for the nozzle contact probe and the temperature sensor on a separate connector.

Yes, they are.

@chipsa82 said in Zesty Nimble with Smart Effector mount:

@CaLviNx great to hear that, do you have a pic of your setup? thanks 😉

erm no not on me so to speak, because im on rotation at work in Saudi and the printer is at home for the next 5 weeks until i am back home again sorry.

Probably, but it will be less sensitive.

great, thanks!

As in the oled thread, the easiest approach would be to use a little Arduino or equivalent to switch between the display chip and the Duet.

I would look into using a STM32, they are arduino compatible and very cheap, last one I picked up for £1.65 from ebay. Alternatively an ESP8266, still cheap <£5 but also includes WIFI.

awesome, thanks!