@cdsmith12 I think the nozzle may be a bit too close still.
Its hard to troubleshoot without knowing what else you've tried and other details, but I will make a few other guesses that hopefully are helpful. These are some of the issues that I ran into with rough first layers
Calibrate extruder steps. If you've been using your printer fine and this is a recently developed issue then calibration doesn't seem like a probable cause but never hurts to double check.
Is your nozzle well used? It may have worn to a larger diameter and now adjacent lines overlap too much.
Does different filament cause the same issue? I had similar problems with some random amazon brand PLA and it turned out the filament had inconsistent diameter.
Old filament that has absorbed moisture? The excess moisture could be contributing to roughness
Hopefully I havent stated the obvious here