Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you have been placed in read-only mode.
Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).
undefined
You need to go to the Machine Settings page and a tab for accelerometer will be there.
@jay_s_uk can you post your config please. Also if possible try a simple hollow cube to see if that also displays the issue please.
@caijonas said in Acclerometer on a Delta printer:
Is it possible to eleminate more than one frequenzy? E.g. M593 P1 F30 F60?
Also interested in that... is it even possible, and will it be in 3.4 firmware?
?
Pin one is oriented to the lower right corner in that picture, yes, and should line up with the dot on the new chip. (oh, and good job!)
661e5e4c-4d12-4301-8f09-c87495f01226-image.png
"ups, my bad. Where can I find it?" found it, thanks
@Tinchus Yes the extrusion needs to happen on a combined XY move.
G91 G1 X100 Y100 E50
for example.
I changed the idler pulleys to printed ones and as aspected, the artifact are less visible and look different. So I have to change the pulleys. They have a wobble. Thanks guys, I will try the ones from robotdigg.
@DocTrucker Thanks for your advice. I installed an shielded stepper wire without grounding it and now it works great.
@dc42 Thanks, that was it what I was looking for
