Topics created by bulka

@bulka said in Printing Settings problem:

@dc42 ok . I calibrated my extruder steps/mm to extrude exactly the amount requested but i want to fix the gumming produced. There is something else ( parameter ) to fix to reduce that ? Or is something that with PETG is normal and impossible to go to 0 ?

I rarely print PETG so I'm not an expert with it. By all means reduce the extrusion factor further if that helps.

installed and configured....works perfectly! 😄

thx for the help

done 🙂 thank you

thank you DC 🙂

I measured the other PT100 and the resistance was around 100 ohms.

Oh yes ! Works!

Now I changed with this one and it works! ...

0_1524317464683_heater13.JPG

Thx for the support!! Really!!

thx Kezat