Topics created by brian

@brian It's possible you deleted it accidentally, or the SD card is failing.

I'd see if you can recover the files from the SD card. There was a thread about that recently, with a recommendation for software to try: https://forum.duet3d.com/post/340947

Ian

https://docs.duet3d.com/en/User_manual/Connecting_hardware/Fans_connecting#duet-2-using-12v-fans-when-vin-is-24v

https://docs.duet3d.com/en/User_manual/Connecting_hardware/Power_choosing

@ziggymanpopo I am using the pt100 daughter board, dont recall having to code anything. I am using the hemera revo, thermister/heater combo. And now the revo high flow, they dont make a 60w 12v version, just 24v, so im stuck with 12v 40w, so slower prints eg 40mm/s with 1.0 nozzle.

After doing the PID, after the fourth try, it started to perform correctly. So as of now all is well, no need to persue it further, and the supplier is sending me a replacement heater, so should be ok for a while, a long while i hope.

Thx for your help.

@jay_s_uk Ok swell, i'll check that out, thx.

@rushmere3d Thank you.

@phaedrux Thank you, i will do that.

@brian said in Adding a Pause, continue prob:

Prusa is now producing better quality prints than S3D, thankfully.

Time to move on. 😉

If you're doing the pause for filament swaps checkout M600. I believe Prusa slicer should be able to insert those and you have complete control over the process using filament-change.g

https://docs.duet3d.com/User_manual/Reference/Gcodes#m600-filament-change-pause

@brian thanks for everyone's help

@phaedrux ok, thanks for all your help

There's also this official guide

https://duet3d.dozuki.com/Wiki/Setting_up_networking_on_Duet

@dc42 ok i changed the distance from 4 mm to 1.5 mm and that worked. Thanks. Dont know why it worked so long before.

Considering that gcode files are typically used as temporary local copies for the printing process, would be nice to be able to enable a global time to leave. E.g. delete gcode files that have not been used for 3 days.

I can read the card on a pc, and tried 4 other cards. When sending commands M20, there is no feedback at all, the message area stays blank.

There is no reaction when trying to move the nozzle. The nozzle temp reads 0, it will allow me set the temp but there is no reaction after doing so.

I have been trying to connect to the board on my pc, but Windows 10 no longer shows com ports, they are now usb ports. So Yat shows no com ports available. If switched to usb ports in Yat it lists all my usb ports and whats connected to them, except it doesnt show the Duet when its plugged in.

I should mention that before it stopped working, the nozzle was at 190 deg and i was extruding some filament, then it suddenly shut down as it would with a heater fault except there was no message, it hasnt worked since.

ok thanks