Topics created by Bmilam

@droftarts that worked! Thank you!

@oliof Thank you, got it updated1

@M1sterd said in USB Drivers:

Does this work over Wifi now as well? I know originally it was said that Windows 10 and 3D printers was around USB, but wondered if this had changed?.

I'm not exactly sure what you're asking here.

@Bmilam said in Duet Wifi resetting part way through prints:

Last reset 00:17:36 ago, cause: power up

That bit (which is in all your M122 reports) indicates that the Duet reset because there was no power to the microcontroller. Possible reasons include:

PSU problem. Note, most 12v ATX PSUs need a dummy load on the 5V rail to prevent them form getting over-voltage on the 12V rail and resetting. VIN terminal block screws on the Duet not tight Something is shorting out or overloading the 5V or 3.3V rail of the Duet. A common cause is endstop switches that are connected to the wrong pins of the endstop connector.

It sounds to me that you have connected the external 5V input of the Duet to the 5V standby output of the PSU. That means that the Duet logic circuits and everything powered from the Duet's 5V or 3.3V rail (including the BLTouch) will continue to be powered when shut off power using M81. It's also why after turning the printer off, you can still use the web interface to upload files and turn the printer back on.