Topics created by BigMoff96

Have you tried printing with that height map? How does your first layer look?

@BigMoff96 said in Getting Error when homing:

G0/G1: target position not reachable from current position

Usually this means you have a delta printer and your homedelta has a move to position the print head at center. However, it can't reach that point because it would require moving one of the carriages up further than it physically could. The solution is to lower the print head first in Z and then command it to center in X Y.

you have to test it. the idea is to increase the force with which the nozzle hits the bed.

@Phaedrux I’ll try resetting the sensitivity and let you know how that goes. I switched the probe type to a P1 based off another forum post and it seems to not be staying high after probing. If I change it to a P5 or P8 it will reproduce the behavior I’m seeing.

I did not see anything and ended up replacing the fuse. All seems to be working in order now.