Best posts made by bfpa40

Good Evening I just got finished ordering my Duet 2 Maestro to replace my entirely stock Ender 3 Control Board with that being said are there any guides on doing this? I know the fans will be an issue as they are 12 Volts. I seen a video where the gentleman used a step down board from 24 Volts to 12 Volts are they necessary and if so where can you purchase them? I am in the USA just saying that in case someone suggests where to buy id prefer to purchase in USA. The Cabling and Connectors seem to be another issue requiring cuts and splicing or using jumper cables. Id like to try in make this a professional install so any suggestions on where to buy the correct cabling with perhaps the right connectors already attached? I appreciate any assistance regarding my questions and look forward to some guidance!
-Brian- (bfpa40@gmail.com)

I got it working..I DID NOT have my hot end up to temp. All is good!