Topics created by baua1024

@baua1024 said in Mainboard 6HC (with SBC) does not start with all Fans Connected.:

That's interesting! I didn't came across these yet.

Arctic PWM PST series - these are indeed 4-wire fans, but the intention is to chain them in a way that you can control all of them with a single PWM signal - ignoring the tacho signals. So, at the controller, you end up with 3 wires.

@martin7404 Thank you Martin! With these values I can get it to heat up until 70C without any errors. I still wish there would be a better solution like a "dumb" heater but at least I can work with it now 🙂

@oozebot Thanks for the Hint but unfortunately I already switched off Power Management. The RPi is connected to a 6.5A PSU that also powers the LED strips in the printer. Since these are not drawing more than 2A(Measured) there should be plenty of power left. I will try another streamer to see if it makes a difference.