Topics created by Arkadiusz

@Arkadiusz it sounds like a power supply problem to me. Send M122 a couple of times to reset the record of minimum VIN voltage; then command movements that cause the motor to stall; then send M122 again and look at the current and minimum VIN voltage in the report.

@Arkadiusz said in Non PWM Led:

@dc42 Never connect the input of a DC-DC converter to a heater or fan output. - I did exactly that, what might be consequences?

I will follow your advice, thanks for letting me know.

It's likely to blow the mosfet that controls the heater or fan output, because of the surge current to charge the input capacitor of the buck regulator every time it turns on. A heater output might last a while, but a fan output is likely to fail quite quickly.

can you adjust the minimum
from something like this
M208 X0 Y0 Z0 S1 ; set axis minima
to
M208 X0 Y0 Z-3.5 S1 ; set axis minima

Pcb breakout board for stepper driver arrived, this solved my issue.

@Arkadiusz you can use dwell with the "P" parameter ans low as P1 for P1 millisecond do something like

G4 P1 M280 Pn S55 G4 P1 .. etc

could work?

Thanks for help everyone, I'm still beginner here and I appreciate all help provided.
Like bearer and Phaedrux said I had to modify config.g.

That's what I was looking for, thanks for confirming that pendant works. Since you are experienced CNC machinist, have you got any pendant that is worth recommending? I wan't to avoid getting product with bad documentation and poor user base.

Cool I know what to do now, thanks for help everyone.

I downloaded and printed a 5inch paneldue case from thingiverse that caused my display to show random windows to pop up and disappear.
It took me ages to realise it was the case applying pressure onto the touch screen.
As @Arkadiusz says, loosening the screws rectified the problem.