Posts made by Andy_M

@andy_m Sorry, found it on E3D

@jay_s_uk Do you know where I can get one that doesn't include the hot end as I don't need the extra expense? They are listed as out of stock on the Duet site and Ooznest is the v2.

@phaedrux Okay, thanks for your help identifying the problem. Is there a newer version now, @jay_s_uk seems to suggest so and it looks different on the Duet product pages?

@phaedrux It was working fine, I'm not sure why, but the fan mount broke. (I work in a school and some of the students can be a little unreliable!) I think refitting the fan must have caused the problem, there isn't a great deal of space. I have another board like this, would it cause a problem if I covered the board with tape if I have to replace anything? Don't want to trash another one!

@jay_s_uk Yes I noticed that, doesn't look like the tracks are damaged, just the blue cover but then they also look very delicate.

@andy_m

@phaedrux Will do.

@phaedrux 26th November 2021

Sorry, only part reply as I was struggling to log on yesterday - technology is working well for me it would seem. I have recently updated the firmware to the latest stable version 3.4.0 and I am also, successfully running another delta with the same set up so I don't think it I have done anything crazy.

I have tried resetting the sensitivity to factory settings but the board is still flashing 6 times continually.

@jay_s_uk Thanks, I'll do that tomorrow.

@droftarts Thanks, I'll try that tomorrow.

The smart effector purchased from Ooznest is flashing six times constantly. They have advised to contact you through the forum before it can be replaced. Is it possible to reset/repair the part. Before it started flashing it was causing problems as it was not triggering, I lowered the sensitivity a little which seemed to sort this issue but now there is a bigger problem to overcome.