Smart effector flashing six times
-
@andy_m
Looks like there is some damage to the traces near the heater output -
@jay_s_uk Yes I noticed that, doesn't look like the tracks are damaged, just the blue cover but then they also look very delicate.
-
-
The damage to those traces looks like it could be the problem. They are quite delicate. Waiting to see what DC42 thinks.
Do you know what caused that scuff? I assume it worked at some point?
-
@phaedrux It was working fine, I'm not sure why, but the fan mount broke. (I work in a school and some of the students can be a little unreliable!) I think refitting the fan must have caused the problem, there isn't a great deal of space. I have another board like this, would it cause a problem if I covered the board with tape if I have to replace anything? Don't want to trash another one!
-
DC42 has confirmed that the damage is likely the problem. The traces are quite delicate.
@andy_m said in Smart effector flashing six times:
I have another board like this, would it cause a problem if I covered the board with tape if I have to replace anything? Don't want to trash another one!
You mean as protection for the traces on the new smart effector? I suppose that could work. It probably wouldn't make it stiff enough to matter. Worth trying.
-
-
@andy_m yes, theres a v3. I have a couple
-
@jay_s_uk Do you know where I can get one that doesn't include the hot end as I don't need the extra expense? They are listed as out of stock on the Duet site and Ooznest is the v2.
-
@andy_m Sorry, found it on E3D
