Topics created by andnosobabin

@dc42 When i use rr_model the information i get back is null. when i go to the page in my browser it doesnt have any values for any of the fields either. im using rrf 3.4.6

Is it possible to just query whatever the source for the DWC % complete? I just need the number.

@andnosobabin if using RRF 3.5.0-rc.1 then use M950 with the E parameter to tell RRF which pin drives the LED strip. I don't think WS2812 LEDs are supported on Duet 2 in older firmware versions but I'll check.

@andnosobabin
Manually level the print bed with the level wheels... and recalculate the Z offset

@Phaedrux Well it seems to have worked this time. I might have used the wrong settings when i used the config tool. It does say this:

Warning: heater behaviour was not consistent during tuning
Auto tuning heater 0 completed after 3 idle and 25 tuning cycles in 2864 seconds. This heater needs the following M307 command:
M307 H0 R0.322 C440.5 D3.78 S1.00 V24.1
Send M500 to save this command in config-override.g

No errors when heating the bed so can I assume that things are all fine then?