@droftarts
i have changed the thermistor but it is same again.
could it be a VSSA fuse problem? as i have lower version of duet board and it has no fuse !
i have the first one board which has not fuse for thermistor, bed or fan.
@droftarts
i have changed the thermistor but it is same again.
could it be a VSSA fuse problem? as i have lower version of duet board and it has no fuse !
i have the first one board which has not fuse for thermistor, bed or fan.
@jay_s_uk
It is a default firmware which i am using from 3D platform to operate the machine.
@droftarts
only fan is working neither the motor nor the heater or thermistor.
@droftarts
okay i will change the thermistor if it can be a problem.
No right now i am using single extruder, actually when i run the command for heating the extruder, it shows the target temp for 2 seconds only then it shows -273 as above.
and when i checked the resistance at the point of thermistor it shows 0 value there.
and yes i downloaded the firmware from 3DP support.
@droftarts
i am not using DWC, right now i am controlling the machine with proterface and Simplify3D.
and iam getting a open circuit error on terminal while i have connected all the things properly.
Error was: Heater error: temperature rising much more slowly than the expected 1.7°C/sec.
it was showing when i run the heater to heat up.
When i send M115 it shows the firmware version 3.1 something
and to upload the files it is showing the parse error
ws200.g
vol_vol.g
common_settings.g
config-override.g
Please check the wires
yes all the LEDs gets on but not the E0_Heat or E1_Heat LED