Posts made by adams2b22

@Phaedrux Thank you very much. I appreciate your help in figuring this out.

@Phaedrux Brand new board and it was mounted before I took the pics.

@bearer Ughhhhh.....dang. It was fine last night, then this. Thanks for the help

It was wired directly to the diagrams. I don't understand. I triple checked everything before I put it on the board.

It has no temp to speak of.

Everything disconnected but usb. No communication to the board at all.

Yes, I did and everything was ok. I followed the instructions and wiring explicitly.

So I checked my wiring, plugged it in, and I get this. No response from the board, and just these 2 LEDs lit up. Can anyone help with this?

Thank you so much! I was pulling my hair out with that one. The only thing left is the filament sensor.

@Phaedrux I have just the standard heatbreak and layer fan. 1 connector from the mks that reads fan. I have another 3 wire cable that runs from the PCB on the carriage, but my assumption was that it runs an LED. Maybe I've just been staring at it too long.

This is probably going to get me laughed off of here, but I'm converting my Sidewinder X1 to a Duet 2 wifi. Thought I was good to go with connections, until I realized that I have no difinitive layout for my fans. I've been staring at this for a few hours trying to decide where to plug my only fan connector into. I see that others doing this have had fan0 and fan1 connected on the PWM inputs. What am I missing here?

@jallen810 Did you happen to have any more info on this? I'm looking to do the same.