Topics created by 3dware

I have already switched from 1.22.6 to 2.04.

I produce printers and always have the same config and firmware on them.

Lan cable is certainly not a problem since I have tested it on other printers and there are no problems.

If this is a guarantee case, I will be happy to discuss this with roland.

@droftarts said in Checksum errors:

My reply about SD card corruption was in answer to @calibanorg, not you. I've edited my post to make that clear. Ideally people should start a new thread for their problem to avoid confusion, but it did sound similar. But then you weren't the OP, either.

@NAK_3D my apologize that i hijacked your post

@droftarts i will open a new post next time -> Thanks for help anyway.

@3dware, did you solve this problem? If not, please provide more details of your machine and the config.g file. Does it have 4 separate nozzles, each with one heater and one extruder, or a single nozzle with one heater and four extruders feeding it? Or something else?

@3dware said in Laser monitor:

if I then unload the macros and load and then continue to print the laser is no longer.

I'm sorry, I don't understand - please explain what you mean.

Please see this thread https://forum.duet3d.com/topic/9708/constant-logging/4 and add to it if you wish.

Hello

No, I have the M122 anywhere in between.

I have now set 1/16 and I1 and it seems to be exactly that.
now it looks good.

thanks for the competent help.

regards

Thank you for the quick reply. We applied the parameter and will see how it works in an longtime test.. Since the room temperature can only been held to the desired value whie the bed heater is running in some cases the value will not be reached.

You can use the Machine Properties page of DWC 1.22.6, or the M119 command, to read the endstop switches in order to test them.

@3dware said in Laser Filament Sensor:

so can I take all the endstops on the duet for the 5 monitor and the 5 enstops on the duex for the 5 endstops of the axes?

Yes that's possible, but only with the 2.03beta firmware. In that firmware, the M574 command has been extended to allow axes to use different endstop from normal.

@3dware said in 5 Hotends:

Hello

How can I lock functions during a print?
For example, I can perform the macros as well as the bedleveling when a print job is running, this should not be possible, as the axes do.

This function should only be possible in the state print job abort or after the restart.

Currently there is no restriction on when you run macros. Some people use macros while a print is running. So we would need to choose carefully which commands can and can't be run while printing.

then another question is there a macro to write the z offset value in the config? I touch with the bltouch and then drive manually on the bed with the nozzle and then want to write the value.

There is a version of the G30 command that sets the probe trigger heigh to the stop height, and after using it you can use M500 P31 to save it and other parameters to config-overridd.g.

one more last I have the laser sensors installed these also flash as they should, but I have not calibrated them yet, all 5 are mounted on the duet2 and not on the duex. how can I activate this that you recognize the runout, and how can I adjust the printer so that he drives at a deviation to a certain position?

See the wiki page about the laser filament monitor, and the M591 command.

what can happen if I mount the laser about 1.2m away from the extruder and connect it with a capricorn tube?

I don't advise that because the motion of filament in the filament monitor won't track the motion of filament in the extruder accurately.