Short circuit error on Kossel XL with duet wifi
-
Sounds like you have a faulty thermistor or faulty wires between the board and the thermistor on your hotend.
-
Sounds like you have a faulty thermistor or faulty wires between the board and the thermistor on your hotend.
Ok I'll look into replacing the thermistor. Is it possible I blew that little board that sits above the hotend? The one i plug everything into.
-
Ahh hold on. I did not realise you had a hotend PCB. That is another point where there could be an error. So measure the resistance of the the thermistor at the plug that plugs the thermistor into the hotend PCB. Also measure the reisitance of the connection from the hotend PCB back to the plug onto the Duet. The thermistor should be 100K ( the wires should be almost 0 Ohms.
-
So i measured the pictured black and green wires and got a resistance of .010 when the mm is set to 2M. Hope that's normal.
https://postimg.org/image/qfql2u489/
I measured the resistance of the thermistor plug (link to picture in a previous post) and got the same .0l reading.
Thanks for all of your help so far everyone. I'm a total noob. lol
-
Does anyone know where i can find the hotend pcb? I tried looking on the E3D website and the Think3dprint3d website but did not see it.
Was also wondering this…since my hotend pcb still powers on my 2 fans connected to it...is it safe to assume that it's ok? I'm now thinking it's just the thermistor that needs to be replaced..
-
The Hotend PCB is on Github here:
https://github.com/T3P3/KosselHotendBoard
It certainly sounds like a new thermistor is the most likely.
-
The Hotend PCB is on Github here:
https://github.com/T3P3/KosselHotendBoard
It certainly sounds like a new thermistor is the most likely.
Awesome, I'll start there. Should i replace both wires coming out of my hotend? or just the thicker red one?
-
Just to confirm, it was my thermistor. I replaced it and it heated up immediately. Thanks for the help everyone!
