Just curious about something

[fcwilt]

Hi,

Is there anyone out there in the Duet firmware development community that is working on making the CAN version of the BIQU Hermit Crab work in the Duet world?

I have read, though not confirmed, that it works in the Klipper world.

Perhaps someone who would consider it?

Just curious - it's an interesting bit of hardware.

Thanks.

Frederick

[jay_s_uk]

@fcwilt the hardware doesn't support CAN-FD so no go I'm afraid

[fcwilt]

@jay_s_uk said in Just curious about something:

@fcwilt the hardware doesn't support CAN-FD so no go I'm afraid

So there are different "flavors" of CAN?

Interesting.

Thanks.

Frederick

[gloomyandy]

I suppose the non CAN version could be made to work with RRF. You could even mount a RRF toolboard on the "fixed" side of the setup to avoid having loads of wiring to the print head.

[fcwilt]

@gloomyandy said in Just curious about something:

I suppose the non CAN version could be made to work with RRF. You could even mount a RRF toolboard on the "fixed" side of the setup to avoid having loads of wiring to the print head.

That is a good idea - I will take a closer look.

Thanks.

Frederick