Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you have been placed in read-only mode.

Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).

Duet Board failure?

3D Printing General Chat

2

2

42

Log in to reply

undefined

carl25 Banned
last edited by

This post is deleted!
undefined 1 Reply Last reply
Reply Quote 0
undefined

droftarts administrators @carl25
last edited by

@carl25 Please provide more information about your setup. What Duet board are you using? What firmware version? Please post your config.g, and the response from sending M122 in the console. Are there any error messages in the console?

You have linked to a website for the stepper motor, but which stepper motors are you actually using?

Ian
TronXY X5S with Duet 3 MB6HC and Roto toolboard : Cartesian bed-slinger with Duet 3 Mini 5+ WiFi and 1LC : RRP Fisher Delta v1 with Duet 2 Maestro : Polargraph with Duet 2 WiFi
1 Reply Last reply
Reply Quote 0

1 / 1