Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login

    Unsolved Splicing a scanning tool board into CAN properly

    Duet Hardware and wiring
    1
    1
    59
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • pogo1213undefined
      pogo1213
      last edited by

      Currently trying to set up the Duet Scanning Probe into my system. I'm currently running a Duet 3 IDEX system with full size tool boards (as in not the roto). I have the probe and Z Scanning board but since there is not can out on the tool board I want to make sure I splice into the CAN correctly. Im running the twisted pairs from the tool distribution board to the tool board that come with the newer distribution boards.

      Is there a suggested way to splice it in. I just want to make sure I don't cause additional issues when doing this.

      1 Reply Last reply Reply Quote 0
      • Phaedruxundefined Phaedrux marked this topic as a question
      • First post
        Last post
      Unless otherwise noted, all forum content is licensed under CC-BY-SA