motor not moving
-
I don't know about that, but I know you can get a USB SD card reader for a few dollars.
-
@Phaedrux ok i'll look for that, thank you
-
@Phaedrux i have the sd card reader, now what am i supposed to do so i can access dwc?
-
Can you take a screen shot of what your root folders look like on the SD card?
Is there a folder named WWW?
Download this zip file
https://github.com/Duet3D/DuetWebControl/releases/download/v3.5.2/DuetWebControl-SD.zip
Extract the contents into the WWW folder. Replacing the files that are there if they are there.
Try connecting again.
-
-
@Phaedrux there is already a file named DuetWebControl-SD.zip, is that normal?
-
@Phaedrux said in motor not moving:
Download this zip file
https://github.com/Duet3D/DuetWebControl/releases/download/v3.5.2/DuetWebControl-SD.zip
Extract the contents into the WWW folder. Replacing the files that are there if they are there.
Try connecting again.
-
@Phaedrux so the only files that should be left in www are the ones in the dwc sip file?
-
@zecreton *zip
-
Yes. You can delete the entire contents of the WWW folder and replace it with the contents of the zip file.
-
@Phaedrux i did it, the status light is now flashing again, but i still can't access dwc
-
@Phaedrux nvm it's all working, it's just that the ip adress changed
-
@Phaedrux im pretty sure the driver is the problem, bc from what we tested before deleting the firmware, the mainboard was sending signals but not the driver
-
@zecreton said in motor not moving:
@droftarts you think it could be the motor? i have another motor i could try it with
So we're back to here then?
-
@Phaedrux yea, but i already tried another motor but not the driver
-
@Phaedrux i tried another driver, it still doesn't work
-
Can you be more detailed on what you've actually changed?
-
@Phaedrux i had another driver that is smaller and goes with a smaller motor, so i changed both but kept the same wires
-
Please more detail than that. When you changed drivers, did you change the config.g to map the axis to the other driver? Did you alter the motor current to match the driver? Photos of your wiring?
The more detail you provide the better chance we have of understanding what is going wrong.
-
