Endtops Low and High
-
Tried G1 then G1 X10 the head moves from left to right G1 X-10 moves the head from right to left
Same for G1 Y10 moves from front to back G1 X-10 back to front. Starting from the left bottom.
back
Y
|Top View |
|
0–-------------------- X
frontleft motor was supposed to be Y while right X but had to switch them to get the correct movement when following the giude in
Configuring RepRapFirmware for a CoreXY printer -
Good, your axes are moving in the correct directions. Now set up your M574 command to specify whether each endstop switch is at the low (minimum) end or the high (maximum) end, set up the M208 commands to specify the upper and lower limits of each axis, and set up the homing files as described at https://duet3d.com/wiki/Configuring_RepRapFirmware_for_a_Cartesian_printer#Homing_files and https://duet3d.com/wiki/Configuring_RepRapFirmware_for_a_CoreXY_printer#Homing_files. You can use the online configuration tool to generate these commands if you wish.
-
Thanks David will do as soon as I get home. Wife made me take here to the beach wont be back until 02/01/18 ;(
Well I can finally read up some documentation.
-
Finally back home tried setting up starts to act almost correctly but I need to know in Web Control Head Moviment
does a +1 = 1 mm? when I do home X and Y when I go back to zero I see the position is 120 x 120 and not 0 x 0.
I do have a 400mm + bed. Does i8t have something to do with the steppers settings? -
Yes +1 should move the head 1mm in the +x direction, +10 should move it 10mm in the +X direction, and so on. If it moves the wrong amount, check the steps/mm settings, which are defined in the M92 command in config.g.
-
Hi David thanks and Yes I was reading the M92 command but how do I calculate the steps, right now I have 200 for all three.
So I know its wrong but rather than trial and error if I know how it would be better-
I have 0.9 stepper motors. -
1. How many teeth are there on the stepper motors pulleys? Are they GT2 pulleys and belts?
2. Is your G92 command before or after any M350 command that you have in config.g? if it is after, what M350 parameters are you using?
3. Are the motors 0.9deg or 1.8deg?
-
1. How many teeth are there on the stepper motors pulleys? Are they GT2 pulleys and belts?
Yes have GT2 20 tooth pulleys and belts2. Is your G92 command before or after any M350 command that you have in config.g? if it is after, what M350 parameters are you using?
I have a M92 X150 Y150 Z150 ; Set axis steps/mm was 200 I changed it to 150 but still not correct. I can not find a G92 command
M350 X16 Y16 Z16 E16 I1 ; Set 16x microstepping with interpolation3. Are the motors 0.9deg or 1.8deg?
0.9deg stepper motors
-
Sorry, I meant M92 not G92. For 20 tooth GT2 pulleys and 0.9deg motors, steps/mm should be 160 on X and Y.
-
Thanks Davis will change now and try it-
