Help with hotend not showing in DWC
-
@frnknstn518 said in Help with hotend not showing in DWC:
@frnknstn518 ok so the bed heats up properly...just figuring out the nozzle heater
How far have you got and what have you tried? From your config.g I can see that you have used G10 to set the initial active and standby temperatures to zero. So if you select that tool by sending T0, the active and standby temperature readings should change to zero. Then if you alter the active temperature, it should heat.
-
@deckingman figured it out. you were correct. I bought a brand new E3D RapidChange Revo Voron Hotend. Its broke before even using it. swapped out for the phateus dragon setup i had and it all works now.
