Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login

    Initial Config Query

    Scheduled Pinned Locked Moved Solved
    General Discussion
    4
    41
    1.1k
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • 900turboundefined
      900turbo @deckingman
      last edited by

      @deckingman I swapped the bed out and nothing happened , started going over every single bit of wiring I will keep it short but basically there's a emergency stop switch on the case and one of the wires was not on all that well. Reconnected it then tried to heat the bed and it heated straight up. I still cannot move my any of my axis but the steppers LEDs now come on so i assume Its just an issue with my g code.
      Major relief anyway as I thought there was a far more serious issue with a broken SSR or Relays.

      1 Reply Last reply Reply Quote 1
      • Phaedruxundefined Phaedrux marked this topic as a question
      • Phaedruxundefined Phaedrux has marked this topic as solved
      • First post
        Last post
      Unless otherwise noted, all forum content is licensed under CC-BY-SA