SAMMYC21 ERCF
-
@VoodooBane I was actually able to find what the components where in Kicad.
-
@VoodooBane Hey there, sorry for the delay. I might have a couple left, let me know if you're still interested.
-
@OwenD Haven't touched it in a hot minute, but as I recall that I had a custom firmware to handle the two steppers. Are you still looking for this?
EDIT: I found the firmware I used, it was the one originally from @Gixxerfast , you'll need to compile it: https://github.com/gixxerfast/Duet3Expansion/tree/cannedboard
-
I need to look at the settings, so I get emailed when someone responds; sorry about that.
I might be interested. I would like to see if I soldered correctly. (it is my first SMD DIY project)
But I would like another one since it is going on an Idex printer if I want to go super extreme, lol.Do you know if @gixxer is planning to make a more modern firmware? That latest is 3.4 from what I remember on Gixxer's GitHub and the new stable release for duet is 3.46
-
@VoodooBane I don't know, I haven't seen them online for quite some time. It's pretty simple, however, to update and compile the firmware. To be honest it's been a hot minute since I touched it last.
I was looking around for someone else and either I sold them all or completely lost them in my shop
I am considering a new order of them, if I get enough interest it would push my decision up a notch.
