Pattern Pressure Advance Calibration

[CrazyCreator]

All fine, or not?

[oliof]

@CrazyCreator following the instructions on the site, I would say you end up at 0.035 to 0.04.

[CrazyCreator]

@oliof stupid question ... in my config.g i have to disable the M572 or is overwritten from the g.code?

[Ellis]

@Robthide37 Sorry just saw this.
I would prefer to keep it on my site but you are welcome to link to it

[Ellis]

@oliof The tool will set your PA using M572 at each increment, and then set it back to the start value at the end. If you have your PA set before running the tool, it will override it.

See Saving Your Value once you settle on a value.

[oliof]

@Ellis Oh sure, I was just sharing my interpretation of the print results.

[Ellis]

@oliof Sorry, meant to tag @CrazyCreator there!

[CrazyCreator]

I don't see any difference ... i'm a old blind man

But i think my steps to big ... now i posted the picture i see it.

[CCS86]

@CrazyCreator said in Pattern Pressure Advance Calibration:

I don't see any difference ... i'm a old blind man

But i think my steps to big ... now i posted the picture i see it.

https://www.amazon.com/gp/product/B08LVN5J3Z/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1

[CrazyCreator]

@CCS86 good idea ...

here is the new one ...

i think 0,034 or 0,035 is the sweet spot.

[oliof]

@CrazyCreator yeah, 0.035 still gets my vote