Pattern Pressure Advance Calibration
-
@Ellis Would you be open to me using your script on my website to replace the current one ? www.advanced3dprinting.com is my site . Or i would love to have you post a blog article and you could put a tip link in it since i do get about 700-900 unique visitors a day so it should get you something in return .
-
All fine, or not?
-
@CrazyCreator following the instructions on the site, I would say you end up at 0.035 to 0.04.
-
@oliof stupid question ... in my config.g i have to disable the M572 or is overwritten from the g.code?
-
@Robthide37 Sorry just saw this.
I would prefer to keep it on my site but you are welcome to link to it -
@oliof The tool will set your PA using M572 at each increment, and then set it back to the start value at the end. If you have your PA set before running the tool, it will override it.
See Saving Your Value once you settle on a value.
-
@Ellis Oh sure, I was just sharing my interpretation of the print results.
-
@oliof Sorry, meant to tag @CrazyCreator there!
-
I don't see any difference ... i'm a old blind manBut i think my steps to big ... now i posted the picture i see it.
-
@CrazyCreator said in Pattern Pressure Advance Calibration:
I don't see any difference ... i'm a old blind man
But i think my steps to big ... now i posted the picture i see it.
https://www.amazon.com/gp/product/B08LVN5J3Z/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1
-
-
@CrazyCreator yeah, 0.035 still gets my vote
-
-
-
-