Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login

    Problem with simple sensor after upgrade

    Scheduled Pinned Locked Moved
    Filament Monitor
    2
    2
    105
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • Alijambo73undefined
      Alijambo73
      last edited by

      I have a Corexy with 4 extruders. After the upgrade to 3.2 I'm having a problem where if I run M591 D0 it shows filament is present but when I start a print it pauses and says no filament detected E0. It worked fine before the upgrade.

      I have this in my config.g "M591 D0 P1 C"e0stop" S1". I can't figure it out. I have read some references to error,g but I'm not sure what that is or if it would be related? Do I need this or is my original pause .g sufficient?

      Any thoughts on the filament sensor not detecting filament after the heaters reach temp and clarification on error.g would be welcomed.

      1 Reply Last reply Reply Quote 0
      • Phaedruxundefined
        Phaedrux Moderator
        last edited by

        One thread is enough. https://forum.duet3d.com/topic/28243/filament-sensor-problem-after-upgrade-to-3-2

        Z-Bot CoreXY Build | Thingiverse Profile

        1 Reply Last reply Reply Quote 0
        • Phaedruxundefined Phaedrux locked this topic
        • First post
          Last post
        Unless otherwise noted, all forum content is licensed under CC-BY-SA