Cannot start print from prusaslicer using a duet3 with sbc
-
Re: PrusaSlicer cannot upload to DWC 2.04/RRF 3
Hi,
I have a Duet3 in SBC mode. I can upload gcodes from prusaslicer but starting a print or simulation does not work.
I checked the logs and I do see a request going from prusaslicer to the duet to start the print, and I see a 200 response from the duet as well. But the print does not start or simulate.
-
@ibash If you are using 3.4-b6, please upgrade to 3.4-b7. It's fixed in the new build - PrusaSlicer sends an invalid content type so I had to add a work-around.
-
@chrishamm said in Cannot start print from prusaslicer using a duet3 with sbc:
@ibash If you are using 3.4-b6, please upgrade to 3.4-b7. It's fixed in the new build - PrusaSlicer sends an invalid content type so I had to add a work-around.
Thank you!
