M84 error after upgrade to 3.3

fcwilt

@mringersoll said in M84 error after upgrade to 3.3:

Hello That is the Start gcode from my Slicer like i was asked for.

Mike

You mentioned Cura and Simplify3D as the slicers you use. Is that correct?

Which slicer was the code you post from?

Was this code you entered in the user code location in the slicer or was it completely generated by the slicer?

Thanks.

Frederick

mringersoll

@fcwilt Hello
slicer generated with the addition for mesh bed probing

mringersoll

@fcwilt oh sorry Cura 4.12.1

mringersoll

@fcwilt Hello
well not sure how to fix it but when i turn on the printer in the console menu of my Paneldue there are two lines back to back that say bad model perimeter it is at the beginning seems to be after the network stuff than wifi starts so how do i start all over with this firmware and such.

fcwilt

@mringersoll said in M84 error after upgrade to 3.3:

two lines back to back that say bad model perimeter it is at the beginning seems to be after the network stuff than wifi starts so how do i start all over with this firmware and such.

I would suspect your M307 commands in the heater section.

The first is M307 H0 B1 S1.5. The S parameter is limited to 0 to 1.

The second is M307 H1 B0 S0.00. While the S parameter is within range it doesn't make sense.

Try setting them both to 1.0 and check again.

Frederick

Phaedrux

@mringersoll said in M84 error after upgrade to 3.3:

I am using an EZabl for my probe and calibration about 2 days ago.

I'd suggest going through the calibration again. See if the trigger height is what it should be. I don't see anything in the gcode that would cause it to trigger so high. so it may be an issue with the probe. Recalibrating would let you test it's trigger height.

mringersoll

@fcwilt Hello
well if this is not in the 1.3,1.5 Range i get a heater error that says heater not heating at a fast enough rate.
The first is M307 H0 B1 S1.5. how do i solve that problem.

Mike

mringersoll

@phaedrux hello i have recalibrated many times still same problem

Mike

fcwilt

@mringersoll said in M84 error after upgrade to 3.3:

@fcwilt Hello
well if this is not in the 1.3,1.5 Range i get a heater error that says heater not heating at a fast enough rate.
The first is M307 H0 B1 S1.5. how do i solve that problem.

Mike

I was just trying to determine if those two error messages were coming from these two commands.

The M307 values shown indicate the heater tuning had not been done so the message about not heating fast enough may go away once tuning is complete.

Frederick

mringersoll

@fcwilt Hello so how is the heater tuning done never done it before please explain.

fcwilt

@mringersoll said in M84 error after upgrade to 3.3:

@fcwilt Hello so how is the heater tuning done never done it before please explain.

In the docs for M303 there is a link to heater tuning in greater detail:

M303 - Run Heater Tuning

Frederick