Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login

    [3.3] Tool heater reports "standby" while actually being "off"

    Scheduled Pinned Locked Moved
    Beta Firmware
    2
    3
    152
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • seeul8erundefined
      seeul8er
      last edited by

      RepRap Object model reports tool to be in state standby while it is "off" in DWC.
      When powered on the tool state is correctly reported to be "off". Switching the tool heater to active followed by standby and off via DWC, causes the object model to return state "standby" while DWC indicates the correct state "off".

      as reported by "/rr_model?flags=d99fn" under "tools" -> "state"

      Board: Duet 2 WiFi (2WiFi)
      Firmware: RepRapFirmware for Duet 2 WiFi/Ethernet 3.3 (2021-06-15)
      Duet WiFi Server Version: 1.26
      Duet Web Control 3.3.0

      fcwiltundefined 1 Reply Last reply Reply Quote 0
      • fcwiltundefined
        fcwilt @seeul8er
        last edited by

        @seeul8er

        It may be that tool state and heater state are not the same.

        I would assume that the DWC is showing the heater state.

        Frederick

        Printers: A FT-5 with the 713 upgrade bits, a custom MarkForged style, a small Utilmaker style, a small CoreXY from kit and a E3D MS/TC setup. Various hotends. Using Duets (2 and 3) running 3.4.6

        seeul8erundefined 1 Reply Last reply Reply Quote 1
        • seeul8erundefined
          seeul8er @fcwilt
          last edited by

          @fcwilt I checked and you are right. The heater state is consistent. The tool state can then be ignored. I see no benefit for now

          1 Reply Last reply Reply Quote 1
          • First post
            Last post
          Unless otherwise noted, all forum content is licensed under CC-BY-SA