First time PETG, dudes
-
@peirof said in First time PETG, dudes:
Thanks,
In the area where I live, Valencia (Spain), on the coast, there is a lot of humidity, it is easy for us to be over 70% ...
It is difficult to keep the filament rolls with low humidity ...
What effects does this humidity have? (on the impression and on the finished piece).
- Only aesthetics?
-Is it more difficult to print? - the backfires when printed?
I'll post that link one more time. It has all the information you need and will answer all your questions. https://www.matterhackers.com/news/how-to-succeed-when-printing-with-petg-filament
- Only aesthetics?
-
@deckingman great article, thx
-
@deckingman said in First time PETG, dudes:
@tecno said in First time PETG, dudes:
Dry your PETG !!! It is hydrophobic
PETG is afraid of water ???
I think you mean hygroscopic. 
Hmmmm marking words you are
I'm just a bloody foreigner making some mistakes.! -
@deckingman said in First time PETG, dudes:
We concluded that the reel must have fallen into a river before it was retrieved and vacuum packed
Apparently some filaments go through water during the manufacturing process.
-
@tecno said in First time PETG, dudes:
@deckingman said in First time PETG, dudes:
Hmmmm marking words you are
I'm just a bloody foreigner making some mistakes.!You seem to be upset. In which case I apologise. I've been trying to learn a foreign language myself for many years. Personally I'm quite appreciative when a native of that language points out mistakes that I have made. Especially when it is done in a polite way and with a
. Fear not, I will not try to help again in the future. -
Me upset NO WAY
I appreciate all help as do all others Ian, so just forget my answer that was written with a glimpse in the eye.
Looking forward to be corrected LOL
-
@tecno That's OK then. Electronic communications, whether that be forum posts, emails, social media messages, and with or without emojis, can easily be misinterpreted without the subtly nuances of facial expressions.
-
I agree, this old fart (a Finn in Sweden) I am a bloody foreigner everywhere L O L
-
What is the humidity that is recommended for the filament? Right now there is 70%. And I don't know what value is adapting, or which one I should look for...
Anyway it seems to me a lot, although the filament does not have that level of humidity, it will have enough...
I would like to know what is the maximum humidity and the recommended for printing. What solutions do you use to control humidity? I've seen several:
-
bake at low temperature, about 60
-
airtight plastic containers
-
I solved prepared for roll (on Amazon there are many) some recommended
-
others (moving to the Atacama Desert,....)
-
-
@peirof I built an enclosure for my printer which is largely airtight. All my filament is stored in that same booth. I use cheap dehumidifiers of the type which use Calcium Chloride. Looking at the amount of water produced, I'd say they do a reasonably good job. I plan to install circulating fans at some point, which should improve the efficiency. I have an ESP based temperature and humidy sensor in the garage where the printer booth is situated as part of my growing home automation system, and also plan to fit another inside that booth. Then I'll be able to measure the humidity inside the booth and see if an electric dehumidifier would be worth the expense.
