electromagnet for tool dock

[spirit.robotics]

@dc42 My Duet are the lasted version v 1.04.

Output M115:

RepRapFirmware for Duet 2 WiFi/Ethernet FIRMWARE_VERSION: 3.3 ELECTRONICS: Duet WiFi 1.02 or later FIRMWARE_DATE: 2021-06-15 21:45:03

About the diodes, they are always active? I supposed it is. In anycase how could be the circuit to put the diode? Thanks

[dc42]

@spirit-robotics the diode will be active if the fan voltage select jumper is installed. As @rjenkinsgb says, the external solenoid supply voltage must be no higher than the selected voltage on the fan jumper (normally VIN).

[spirit.robotics]

@rjenkinsgb Today I connect the board by USB and work fine, and connect a 5V FAN in the always ON fan and the fan work well.

However Im little worried if I try to connect the electromagnet, maybe the reason of the shortcut is different...

Just to understand, confirm ... in a board V1.04 I have the flyback diodes in place with the fans, so, in theory if I connect to the PWM Fan pin a small electromagent should be work?

The Electromagent, rated for 12V 0.2amps, but connected to the 5V pwn fan pin only need 0.09 amps ... could be work?

[dc42]

@spirit-robotics what position is the fan voltage section jumper in?

And what VIN voltage are you using?

[spirit.robotics]

@dc42 this is a test from my power supply, just to check.

I want to connect the electromagnet to a pwm fan pins at 5V, from the reading I understand that it will work because the board have the flyback diode and the current is small.

My idea is hold with the electromagnet my tool, I already tested the electromagnet with the DC power supply and the current is only 0.09 ampers, but still have enough force to hold the tool without getting hot the electromagnet.

Please let me know your recommendations.

[A Former User]

This post is deleted!

[A Former User]

@spirit-robotics
Hi again
My solution is still working good. It's quiet simple.
I could share my solution...

Cheers
Richard

[spirit.robotics]

@gruna-studio Thanks, sure if you like, I already have my design, I want to hold a small iron plate attached to the tool with the electromagnet, no moving parts.

Im only double check how operate the electromagnet without burn again my board.

Best

[spirit.robotics]

@spirit-robotics Hi dc42, please let me know your comments. Best

[spirit.robotics]

@spirit-robotics Hi everyone, weekend was busys, but today I find the time to test. It's work now the electromagnet into the PWM fans. Thanks to all

Best