Pause delayed heater shut off ?
-
I ask this question before , but I don't think it was possible then, is it now on 3.2.2 ?.
If it goes in to pause mode due to the filament out sensor or trigger I want the heaters to switch off after a set time.
I've worked out how I program it , in pause.g do what normally happened , after go into while loop wait for state.upTime+timedelay to be greater than State.upTime.
But the problem is I can store state.upTime+timedelay to make it a variable ? -
@peter247 only in 3.3
The RC releases are quite stable -
