End/limit switch-movement inhibit
-
Repetier firmware had a provision for inhibiting travel beyond the homing switch. The homing switch, after referencing would act as a limit switch which would restrict any movement beyond the switch. The duet firmware does not seem to have this am I right?or it can be set this way?
-
@mendelevium you can convert an endstop into a trigger using M581. That would replicate the functionality.
Just remap them back to endstops at the start of the homing file -
If you have your M208 limits set correctly the firmware should already prevent travel beyond the limit switch or defined printable area. Otherwise remapping to a estop trigger is the best option.