I want feedback for my enclosure for the Duet 3 mini
-
Hey there, I made an enclosure for the Duet 3 mini + Raspberry Pi + 7i touchscreen
and as far as I can tell I am the first on Thingiverse to do so.You can find it here.
What additional features would you like to see in the enclosure?
I am thinking of different mounting options and different fan sizes (current one is 140mm).
Maybe a different power connector?
-
An option for 120mm PC fans would probably be wise since they are more widely available.
-
Looks pretty neat!
A few things -
1)Under-board Cooling for those drivers.
2) Wire Tie-down Locations. always useful.
3) buck converter for the rpi built in? would be neat to plug in only 24v, and have a spot pre-wired for 5v converter and something to hook to the pi. -
@luke-slaboratory
Thanks for your suggestions!- I've somewhat implemented underboard cooling. There's holes on the right side and a skirt around the duet, the fan will then push air through the "tunnel".
- will implement
- good suggestion, didn't think about that at all. My Pi is powerd through the ribbon cable from the duet, which in turn is supplied via the ext_5v_in header from the psu.
Stay in school
-
Hello Nikscha. I have seen this, but I didn't know it was yours. Great job!
-
@nikscha Two more suggestions: Some space for an SSR for those that run AC beds. Maybe locations for wago connectors for easier cable maintenance.
