Ender 5 + Duet wifi starts on wrong side g29

lui2004

not all

only setup for :

Endstop,motor drive

peter247

@lui2004 X and Y , Z motor should be the same ( MUST ) , But E could be any direction , that is a suck it and see.

O.K , lets make a macro and see if we are on the same page.

Move the head it middle of the bed and try.

G91
G1 H2 Z5 F6000
G1 H1 X 10 F3000
G1 H1 Y 10 F3000
G1 H2 Z-5 F6000
G90

Does it move to the right and too the back 10mm in each direction ?

If it doesn't change the motor direction until it does !!!!

lui2004

the macro will only move the bed up and down

peter247

@lui2004

O.K to safe , it looks like you can see a 10mm change .

G91
G1 H2 Z5 F6000
G1 H1 X 100 F3000
G1 H1 Y 100 F3000
G1 H2 Z-5 F6000
G90

This should lift the head up , move right and to the back 100mm now.

lui2004

@peter247 said in Ender 5 + Duet wifi starts on wrong side g29:

G91
G1 H2 Z5 F6000
G1 H1 X 100 F3000
G1 H1 Y 100 F3000
G1 H2 Z-5 F6000
G90

only z moves up and down few mm

but x and y dont moves

peter247

@lui2004

o.k confirm this :- After you run the macro and it goes up and down , does it say homed X an Y ?

lui2004

yes after i run the macro it move only the z but x and y was homed

peter247

@lui2004 o.k wiser .

; Endstops
M574 X2 S1 P"!xstop"    
M574 Y2 S1 P"!ystop"

So have you changed this and what too ?

lui2004

yes i have changed it

peter247

@lui2004 With the ! ?

lui2004

yes with the '!'

peter247

@lui2004

O.K , I'm hoping you are doing this which the head in the middle of the bed ?

Try removing the ! and try running the macro again.

lui2004

it will move now with '!'

but the origin 0,0 back right the webinterface showa me back right 235,235

peter247

@lui2004

o.k , will have the switch Normally open or Normally close part working and tested .

( I will assume you are centring the head each time )

NEXT TEST , try the same macro , while it's moving touch the X axis switch first and it should stop and move in the Y direction , touch than Y switch and than should stop and say homed X and Y .

lui2004

yes everytime in center the bed

Test succesfull x and y are homed

but why on right back ( 0,0 ) is now 235,235 and not 0,0 ?

peter247

@lui2004

Left , front is 0, 0 , right / back and fully homed should be 235 , 235 ,
Did my macro go right and back towards the X and Y homing switches ?

IMPORTANT have you a Ender 5 ( not pro or plus )

a few change to the homing file , but it is now much easier to set up , now you don't have a bltouch but a switch for z axis .