Height map makes my bed look warped…Why???
-
i thought it only went to 7
-
Nope, all the way to 9.
-
I ran into more issues when I calibrated over 6 factors. Six ended up working great for me. More wasn't better in this case when I set up my delta. The trigger height corrections are what you'll need to establish and plug in. Once you get those nailed, you'll be off and running.
-
9 factors is looking better for me
im using a piezo in the print head so i have no variation in trigger height
Calibrated 9 factors using 17 points, deviation before 0.159 after 0.034
-
That's a lot better. What are your M665 and M666 changes?
-
config has
M665 R135.59 L330.77 B135.59 H235.444
M666 X0 Y0 Z0after calibration i got
M665 Diagonal 344.383, delta radius 138.954, homed height 235.472, bed radius 135.6, X -0.050°, Y -0.359°, Z 0.000°
M666 Endstop adjustments X-0.20 Y0.13 Z0.07, tilt X-0.23% Y0.22% -
M500 will save that to override.g and if you have M501 at the end of your config.g, it'll use those settings.
-
so yes, 9 made the calibration look good, but it did not make it print good. back to 6 i guess
-
What is wrong with the print?
-
Things where great near the center, but out near the edges it went right off the bed. I guess it
changing the arm length by 14mm was not the best -
How big is your bed?
-
try 8 factor cal
-
Is there a list somewhere of what the different factors are? i saw one once but it only went up to 7.
-
https://duet3d.com/wiki/Calibrating_a_delta_printer
found it, going to give 8 a try
-
I think that is better, you can even see on the heightmap where i have binder clips holding the heatspreader plate down.
Calibrated 8 factors using 17 points, deviation before 0.087 after 0.056
-
Earlier you said it went off the bed. Are you saying it tried printing off the edge of the bed? Is your build plate 270mm+?
-
it actually went off during a calibration not a print, the first time through the calibration it looked good, later it went off the edge, yes the bed itself is 310,
-
Is this a Rostock, by chance?
-
in concept yes…but i think the heat bed is the only actual real rostock part,
