best laser install ?
-
I have the duet 2 with rrf3.2.2this 30-W 12v3a laser would it be best to use a separate power supply and hook up to the fan or or using a buck converter to the center pin fan Vin jumper was also thinking about getting a d u e x board will I be able to directly hook up to that
-
Do you have any spec sheet for the laser? Schematic for the board? Can you show a better close up photo of the board front and back?
-
![0_1614805502250_IMG_20210303_130159.jpg](Uploading 100%)
![1_1614805483207_IMG_20210303_130153.jpg](Uploading 100%) ![0_1614805483207_IMG_20210303_130159.jpg](Uploading 100%)30W General Specification:
Model:NEJE Module 30W
Heatsink Material:Aircraft Aluminum + Brass Shell
Luminous Color:Blue
Section Size:40mm x 40mm
Cooling Mode:Temperature sensor intelligent control + 10000 rpm 40mm cooling fan
Dimension:60 * 40 * 40mm
Adapter Plug:5.5 2.1 port
Can Engrave:MDF/Balsa/Paper/Wood/Fabric/Plastic/Leather/Plywood/Foam Paper/Anodized Aluminum
Can Not Engrave:Metal/Glass/Stone/Ceramics/PCB/Stainless Steel/Reflective Material/ Transparent Material
Technical Parameters:
Module Input:20-30W
Optical power output:7.5W (7500mW)
Wavelength:445-450nm
Beam Shape:Dot (Focusable)
Working Voltage:DC 12V
TTL&PWM Modulation:YES, Compatible with Both TTL & PWM Modulation
Input Voltage:DC12V 3A
PWM/TTL Input:DC3.3V-12V
Input Interface:PH2.0-4Pin (+,-, PWM/TTL, Temperature), 3Pin (+,-, PWM/TTL) , 2Pin+2Pin (+,-) + (PWM/TTL,-)
NOTE:Temperature interface can be disconnected,NEJE provides text instructions for temperature acquisition on wiki.
Drive Mode:External ACC![alt text](image url)
Safe temperature range:<60 ℃
Module weight:202g ( The lighter the weight, the smaller the move inertia, the better the performance )
Life Time:10000-20,000 hours![0_1614805350779_IMG_20210303_130159.jpg](Uploading 100%) -
Your uploads didn't work.
-
-