Fan Controll Issue
-
Thanks ill go try, the software rebooted the duet, ill try turn in off and on physically now
-
@PeterA said in Fan Controll Issue:
M308 S0 P"bedtemp" Y"thermistor" T100000 B4138 ; configure sensor 0 as thermistor on pin
M308 S1 P"e0temp" Y"thermistor" T100000 B4138 ; configure sensor 1 as thermistor on pin e0tempalso B4138 is incorrect. find the correct beta value in your thermistor documentation.
-
@Veti
OK, i don't have any issues with the hot end or bed heating up and maintaining temp, not sure i understand the connection with the fans? -
its not connected. but an incorrect value with result in an incorrect temperature being displayed.
it could show 200 but the actual temperature could easily be 180
-
@Veti said in Fan Controll Issue:
M106 P0 S1
OK ill look into that, but just to confirm its not related to the fan issue?
-
that command is to enable the fan to 100%
-
@Veti said in Fan Controll Issue:
B4138
ok, after changing that the fans still don't come on at all. Ive put the jumper onto always on and the fans con on just fine.
-
@PeterA
no the beta has nothing to do with the fanIve put the jumper onto always on and the fans con on just fine.
what jumper?
-
Ok.. so after plugging the jumper into always on then back to pin 1 they are now working????
-
Must be like a faulty wiring connection.??
-
Jip, everything now seems to work, I'll replace the connector, it looks OK but somethings off.
-
@Veti said in Fan Controll Issue:
B4138
Thanks for your help.
Regarding the B4138, i don't have any documentation regarding that. Ive looked through old setups and that's the one that its always used. How could i test this is correct? -
where did you buy the equipment?
and you never answered the question about what jumper you are talking about?
-
Ill go see where it came from. Sorry not a jumper, I meant the connector from the fans that go onto the board.
-
@Veti said in Fan Control Issue:
find the correct beta value in your thermistor
Evidently my hot end temp sensor
is as follows:
2M NTC 3950 100K Ohm High Temperature ResistanceCould i ask how and what setting to put in to the config.g for this?
-
B3950
-
-
Thanks for your help Veti