Printing
-
confConfiguration file for Duet 0.6 (firmware version 1.21)
what duet do you have?
apparently you selected duet 1 in the config tool, yet you write you have a duet 2.what firmware version are you running?
if you are starting new and you have a duet 2 you should update to firmware 3.11.
see https://duet3d.dozuki.com/Wiki/Installing_and_Updating_Firmware
do not forget to update the wifi firmware and the duet web control.easiest is to update using bossa if you have a very old version.
then go through these steps.
https://duet3d.dozuki.com/Guide/1.)+Getting+Connected+to+your+Duet/7 -
-
@Veti the config may say it is for a duet o.6 but has been heavily modified. My firmware is 2.05
-
@Phaedrux Long, rather weary, story. I thought I had fried my ethernet duet 2 so bought a wifi one. After a while I got a config file that appeared to do what it should so put it back in the ethernet board. I connected through YAT and for the first time got an IP address, I have now connected direct to my router and the USB cable and the web console actually opens but there is an error message. "Failed to get file list"" directory 0:/macros not found
-
directory 0:/macros
just create that folder on the sd card
see
https://duet3d.dozuki.com/Wiki/SD_Card -
When you have a USB terminal up please send M122 and M98 P"config.g" and post the results.
What do you have on your SD card? It sounds like you're missing the directory structure. Are you perhaps also missing the web interface files as well?
https://duet3d.dozuki.com/Wiki/SD_Card#Section_Creating_the_file_structure
-
@Phaedrux Yes I am probably missing something . I have inputted 'Duet2CombinedFirmware.bin' and confirmed that I have 2.05.1 entered. I have also loaded 'iap4e.bin'but I think need a web control input.
I suspect that my sys file is in a bit of a mess so will start from the beginning
-
@Veti OK so I create a folder but where do the files for that folder come from,?
-
thats where your macros go
-
@Veti thanks that seems to have done it